Pfeiffer Vacuum ASM 310 - Appendix; Tree diagram of the Settings menu

12 Appendix
12.1 Tree diagram of the Settings menu
Next tables indicate the default settings for the leak detector.
When the leak detector is switched off, values and parameters are saved for the next start-up.
Access: Settings Screen + Menu [Measurement] Choice - Setting limit
Tracer Gas
Helium 4
1)
Mass 3
Hydrogen
Set points Pollution Status Enabled
Disabled
1)
Setting
(if enabled)
1 · 10
-19
– 1 · 10
+19
1 · 10
-05 1)
Hard Vacuum
Set Points
Reject point
1 · 10
-13
– 1 · 10
-06
1 · 10
-07 1)
Warning point Status
Enabled
1)
Disabled
Setting
(if enabled)
0–100%
20%
1)
Sniffer set points Reject point
1 · 10
-12
– 1 · 10
+06
1 · 10
-04 1)
Probe Clogged
1 · 10
-19
– 1 · 10
+19
1 · 10
-06 1)
Warning point Status
Enabled
1)
Disabled
Setting
(if enabled)
0–100%
20%
1)
Correction factor Status Enabled
Disabled
1)
Setting
(if enabled)
1 · 10
-18
– 1 · 10
+18
1 · 10
+00 1)
1) Default setting
2) General information: read only
3) No default setting: setting performed by the user at the 1
st
detector start-up
4) Information indicated on the calibrated leak used for calibration or on its calibration certificate.
Appendix
80/98