For quick access from the main screen, use the [INFOR.] function key.
Detector information
Reminder: for viewing only in this menu
Access: Menu [Maintenance] [Information] [Detector]
Timer Running time for detector
Date and time Date and time
Software release .LC4 Control panel firmware information
Software release .CPX Leak detector firmware information
Software release .CEN Analyzer cell firmware information
Inlet pressure Inlet pressure
Reject point Set reject point
Warning point Warning point set
Correction Correction factor status
Tracer gas Tracer gas selected
Filament Filament selected
Cell status Status of the cell
Method Test method set
Mode (if 'hard vacuum' method)
Probe type (if 'sniffer' method)
Test mode selected
Type of probe selected
Calibration Calibration set
Last calibration Time since the last calibration performed
Next maintenance Time before the next maintenance to be performed
For quick access from the main screen, use the [TIMER] function key.
Analyzer cell information
Reminder: for viewing only in this menu
Settings menu
68/98
To Next Page
Loading...
