Directions For Use
EN 39DVDR70 & DVDR75/0x1 3.
68
K
User preferences
In this section you will learn how to set your user preferences on the DVD recorder. The
symbols have the following meanings:
Picture setting
Sound setting
Language setting
Additional settings
Remote control settings
Disc settings
Recording settings
Installation
1 Switch on the TV set. If required, select the programme number for
the DVD recorder.
2 Press SYSTEM-MENU on the remote control. The menu bar
appears.
3 Select '
A
' using D or C and confirm with CH- B .
4 Select the appropriate function with CH- B or CH+ A and confirm
with C .
5 Select the appropriate line using CH- B or CH+ A and confirm
with C .
6 Select the appropriate function using CH- B or CH+ A or the
setting with D or C .
7 Confirm the new setting by pressing OK .
8 To close the menu item, press D .
Picture settings
You can choose the following features in this menu:
Picture
TV shape 16:9
Black level shift Off
Vertical video shift ï
SCART video RGB
'TV shape'
The picture signal from your DVD Recorder can be set to match your TV screen.
'4:3 letterbox': for a 'wide-screen' picture with black bars at the top and bottom
'4:3 panscan': for a full-height picture with the sides trimmed.
'16:9' : for a wide-screen TV set (screen edge ratio 16:9)
'Black level shift'
Adapts the colour dynamics for NTSC playback
User preferences
67
Problem solving for programmed
recordings
PROBLEM SOLUTION
The DVD recorder is
not responding
bWhile a programmed recording is being made, you cannot operate your DVD recorder manually.
If you want to cancel the programmed recording, press STANDBY m .
'Switch off, timer
recording' flashes on
the TV screen.
bThe DVD recorder was switched on several minutes before the start of a programmed recording.
Switch off the DVD recorder using STANDBY m . A programmed recording (timer) will only
function if the DVD recorder is switched off ( STANDBY m button).
Error message: 'Insert
recordable disc'
bEither a disc has not been inserted or the disc cannot be used for recording. Insert a disc on
which recordings can be made. Switch off the DVD recorder using STANDBY m .
The error message
'Disc locked' appears
briefly on the screen.
bA write-protected disc has been inserted. Undo the write protection (see 'Preventing accidental
erasing of discs' in 'Manual recording') or insert a different disc.
Error message:
'Memory full'
bIf this error message appears after pressing TIMER , then all TIMER blocks are already
programmed. No more recordings can be programmed. Press the C button. If you want to clear
or check a programmed recording (TIMER block), select it with CH+ A or CH- B .
The 'Data error'
message appears on
the screen.
bThe data for the recording could not be transferred. Please check date, start time and end time
of the programmed recording.
The 'Collision'
message appears on
the screen.
bTwo programmed recordings overlap.
bIf you ignore this error message the show with the earlier start time will be recorded first. The
start of the second show will not be recorded.
bChange the setting for either of the two recordings.
bClear either of the two recordings
ENGLISH
Programming a recording (TIMER)
To Next Page
Loading...
