203
18
18 Recording
Central
Recording
For central recording from the bedside, your monitor must be connected via a network to an
Information Center. You can use either the M1116B 2-Channel Recorder or the standalone M3160A
4-Channel Recorder. See the documentation supplied with the Information Center for information on
the 4-Channel Recorder.
When an X2 is connected to a host monitor (Companion Mode is indicated):
•No central recording is available on the X2. Central recordings are made via the host monitor.
• Local recordings may be available. See the Instructions for Use for your host monitor for details.
Starting and Stopping Recordings
The recordings pop-up keys let you start and stop recordings. Select the Main Setup SmartKey then
select Recordings to call up the line of pop-up keys. Scroll right or left to see any pop-up keys not
displayed.
Recording Without a Template
To record without a preconfigured template, selecting the waves you require,
1 Select the Main Setup SmartKey then select Recordings.
2 Select the pop-up key Select Waves,
3 Use the pop-up keys to choose up to three measurement waves to be printed on the recording. If
you want fewer than three waves on the recording, select the waves you want then select the
Continue pop-up key.
4 Select one of the recording speed pop-up keys to set the required recording speed.
5 Select the Start pop-up key to start the recording.
Select Waves recordings use default values for any recorder settings not defined: runtime is
continuous, overlapping is set to non-overlapping.
Delayed
Recordng
RT A
Recordng
RT B
Recordng
Select
Waves
Setup
Recordng
Stop all
Recordng
To Purchase, Visit Avobus.com or call 1-800-674-3655
To Next Page
Loading...
Need help?
General
