Alarm and Measurement Default Settings 25 Default Settings Appendix
281
Alarm and Measurement Default Settings
Settings are only entered once per table row if they are the same for all patient categories
1
.
Alarm Default Settings
1.A profile “Outdoor” exists for use in typical outdoor conditions (bright sunlight, higher ambient noise). See the Configuration
Guide for details.
Alarm Settings Factory Default
Alarm Volume 5
Alarms Off 2 min.
Pause Al. 5min Enabled
Pause Al. 10min Enabled
Auto Alarms Off Off
Alarm Off Reminder Off
Visual Latching Red & Yell
Audible Latching Red & Yell
Alarm Reminder On
Reminder Time 3 min
Alarm Sounds Traditional
Red Alarm Interval 10 sec
Yel. Al. Interval 20 sec
Alarm Low 4
Red Alarm Volume AlarmVol +2
Yell. Alarm Volume AlarmVol +0
Inop Volume AlarmVol +0
Auto Increase Vol. 2 Steps
Increase Vol Delay 20 sec
Keep Blinking No
Relay 1 Sensitiv. R & Y & I
Relay 2 Sensitiv. Red & Yell
Relay 3 Sensitiv. Red
Inop Relay Latency 5 sec
Yel. Relay Latency 2 sec
Alarm Text Standard
No Centr Mon Min Vol 4
To Purchase, Visit Avobus.com or call 1-800-674-3655