Check there is voltage between pins 22 and 26 of
the interface wiring for around two seconds when
switching to «ON».
Check the resistance of the primary coil between
pin 22 of the interface wiring and the green black
cable of the injection load remote control base with
the control unit disconnected and the remote con-
trol disconnected.
Primary resistance ~ 1 Ohm
Inspecting the spark plug shielded cap
Measure the shielded cap resistance.
Electric characteristic
Resistance:
5 KΩ
MP3 400 i.e. Injection
INJEC - 39
To Next Page
Loading...
