CLOTHES. IF THIS HAPPENS ACCIDENTALLY,
WASH WITH WATER.
Recommended products
AGIP BRAKE FLUID DOT4 Brake fluid
FMVSS DOT4 Synthetic fluid
Headlight adjustment
Proceed as follows:
- Position the unloaded vehicle, in running order
and with the tyres inflated to the prescribed pres-
sure, onto a flat surface 10 m away from a half-lit
white screen; make sure the scooter axis is per-
pendicular to the screen;
- Remove the headlight assembly central cover.
- Turn on the headlight and check that the border
of the projected light beam on the screen is not
higher than 9/10 or lower than 7/10 f the height
from the ground to the centre of vehicle headlamp;
- Otherwise, adjust the headlight with the screws
« A» indicated in the figure
N.B.
THE ABOVE PROCEDURE COMPLIES WITH
THE EUROPEAN STANDARDS REGARDING
MAXIMUM AND MINIMUM HEIGHT OF LIGHT
BEAMS. REFER TO THE STATUTORY REGU-
LATIONS IN FORCE IN EVERY COUNTRY
WHERE THE vehicle IS USED.
Maintenance MP3 400 i.e.
MAIN - 14
To Next Page
Loading...
