PIAGGIO MP3 400 i.e. - Taillight Assy.

- Remove the five screws on the shield back plate
rear part.
- Remove the two shield back plate front screws,
see figure.
- Remove the two shield back plate lower screws.
- Remove the external temperature sensor con-
nection.
See also
spoiler
Legshield
Taillight assy.
Open the rear case cover, remove the two screws
«D», and then, the other four fixing screws «D» to
pull out the headlight assembly from its fitting.
Follow this procedure to remove the bulbs:
Remove the snap-on bulbs «B».
Remove the bulbs «A» on the bayonet by turning
them 30° clockwise.
Chassis MP3 400 i.e.
CHAS - 8