PIAGGIO MP3 400 i.e. - Front brake pads

Characteristic
Thickness of a new front disc
4.0 mm
Disc thickness at wear limit (front)
3.5 mm
- Remove the wheel and check using the appro-
priate tools that the axial run-out of the brake
surface is within the prescribed limits.
- If this is not the case, replace the disc and repeat
the test.
WHEN INSTALLING, THOROUGHLY CLEAN
THE DISC AND ITS SEAT ON THE HUB.
Characteristic
Max. axial run-out
0.1 mm
Front brake pads
Removal
- Remove the brake calliper.
- Remove the Benzing snap ring of the pad pin.
- Slide off the pin paying attention to collect the
retaining spring of the pads.
MP3 400 i.e. Braking system
BRAK SYS - 9