PIAGGIO MP3 400 i.e. - Front brake calliper

Brake fluid pipe-calliper fitting 20 ÷ 25 Pad fas-
tening pin 20 ÷ 25
Refitting
- To fit the rear brake calliper, follow the removal steps but in reverse order; be careful to tighten the
screws to the prescribed torque.
Locking torques (N*m)
Screw tightening calliper to the support 20 ÷ 25
Front brake calliper
Removal
- The operations described refer to only one cal-
liper but apply to both.
- Remove the wheel.
- Undo the two fixing screws to the plate and re-
move the calliper.
Overhaul
- Remove the rear brake calliper.
- Suitably hold the brake calliper in a clamp
- Remove the two calliper coupling screws as
shown in the photo
- Remove the two pistons from the calliper body
with the aid of short blasts of compressed air
through the brake fluid holes
- Remove the dust ring and the O-ring of each half
calliper.
- Remove the O-rings in the half calliper.
N.B.
WHEN REMOVING THE O-RINGS, BE CARE-
FUL NOT TO SCRATCH THE HALF CALLIPER
SEATS
Braking system MP3 400 i.e.
BRAK SYS - 4