Unscrew the two pad pin screws, remove the pads
with the spring.
When refitting, tighten the two screws to the pre-
scribed torque and use Threadlock.
When refitting, adjust the cable properly so that the
switch is pushed when the system is unlocked.
Refit the spring/toothed sector unit, hold the crank-
case in a perfectly horizontal and stable position,
place the spring/toothed sector unit keeping it per-
fectly perpendicular to the bearing already fitted on
the crankcase; if necessary, slightly hit the unit
shaft end with a mallet and protect the thread by
screwing in a nut.
MP3 400 i.e. Suspensions
SUSP - 21
To Next Page
Loading...
