Replacement
Replace oil and filter as indicated in the scheduled
maintenance table. Empty the engine by draining
the oil through drainage plug «B».
To facilitate oil drainage, loosen the cap/dipstick
«A».
Once all the oil has drained through the drainage
opening, unscrew and remove the oil cartridge fil-
ter «C ».
Make sure the pre-filter and discharge tap O-rings
are in good condition.
Lubricate them and refit the mesh filter and oil
drainage plug, screwing them up to the specified
torque.
Refit the new cartridge filter being careful to lubri-
cate the O-ring before fitting it.
Change the engine oil.
Since a certain quantity of oil still remains in the
circuit, engine oil must be added through the plug
«A». Then start up the scooter, leave it running for
MP3 400 i.e. Maintenance
MAIN - 9
To Next Page
Loading...
