Pilz PSEN sc ME 5.5 08-17 - 8 Psenscan Configurator; Basics; Installation; System Requirements

PSENscan Configurator
Operating Manual PSEN sc ME 5.5 08-17
1005388-EN-01
| 73
8 PSENscan Configurator
8.1 Basics
The PSENscan Configurator is a graphic tool
} For configuration of the safety laser scanners of the PSEN sc ME 5.5 08-17,
} For incorporation of the safety laser scanner into the network,
} For monitoring the safety laser scanners in the network,
} For creating reports,
} For password administration of the safety laser scanner of the PSEN sc ME 5.5 08-17
8.2 Installation
8.2.1 System requirements
Operating system: Windows 7, 10 or XP (32 Bit and 64 Bit)
Processor: Pentium 4, min. 2 GHz
3GHz recommended
RAM: Min. 2 GB
Available hard drive space: Approx. 70 MB
Graphics card: Min. 1024 x 768 pixel resolution, 65536 col-
ours
For optimum performance of the system, a
current graphics card with 3D acceleration
should be used, and the 3D acceleration
should be activated.
To view the documentation: Adobe Acrobat Reader, from Version 7.1.0
Interfaces: A free 100Mbps Ethernet interface for data
transfer to the safety laser scanner
Access rights: Network access for PSENscan Configur-
ator, profile Private
8.2.2 Install PSENscan Configurator
Procedure:
1. Switch on your computer and start up the operating system.
2. Download the software PSENscan Configurator from the download area on the Pilz
homepage under http://www.pilz.com/support/downloads/.
3. Double-click on the unpacked file.
The software PSENscan Configurator is installed.
The installer will guide you through the installation.