Pilz PSEN sc ME 5.5 08-17 - Diagnostic Information; Error

Operation
Operating Manual PSEN sc ME 5.5 08-17
1005388-EN-01
| 98
10.3 Diagnostic information
10.3.1 Error
Message in the display Error/cause Description/measure
Icon Text
CLEANW1 The front panel of the safety laser
scanner must be cleaned.
Clean front panel
INPUTCF1 Error in the configuration or the wir-
ing.
Check whether the wiring [ 54]
and the configuration [ 78] will
match.
INPUTCF2 Configuration error. In the configuration, check the con-
figured state transitions and switch-
ing operations.
INTF1 An error occurred during the system
test.
Perform a reset of the safety laser
scanner [ 104].
If the error persists, please contact
Pilz.
INTF2 An error occurred during the system
test.
Perform a reset of the safety laser
scanner [ 104].
If the error persists, please contact
Pilz.
INTF3 An error occurred during the system
test.
Perform a reset of the safety laser
scanner [ 104].
If the error persists, please contact
Pilz.
INTF4 An error occurred during the system
test.
Perform a reset of the safety laser
scanner [ 104].
If the error persists, please contact
Pilz.
INTF5 An error occurred during the system
test.
Perform a reset of the safety laser
scanner [ 104].
If the error persists, please contact
Pilz.
INTF7 An error occurred during the system
test.
Perform a reset of the safety laser
scanner [ 104].
If the error persists, please contact
Pilz.