PocketWizard FlexTT5 - Speedlite Compatibility

Canon Compatibility
15
Incompatible Pre-2004 Cameras
1D (Mark I) 1Ds (Mark I) D60
10D D30 Rebel (300D)
DCS 3 DCS 1 D2000 / D6000
BASIC TRIGGER MODE: Almost all cameras and flashes are compatible with the MiniTT1 and FlexTT5 when the
radios are configured for Basic Trigger Mode. Basic Trigger Mode disables all flash power control and TTL
functions of the radios.
Canon's PowerShot cameras, such as the G9, G10, G11, G12 and earlier models, are not supported with our radios.
Although these cameras can use many of the same flashes as modern Canon DSLRs, they use a very different
implementation of Canon's ETTL protocol.
Speedlite Compatibility
Special Note: Canon Speedlite models 580EX and 580EX II, and especially the older 430EX (not the newer 430EX
II), emit RF interference that can substantially reduce the effective operating range of many radio slaves, including
the FlexTT5 when used as a receiver. For these model flashes, please utilize the mounting suggestions on
PocketWizard.com
[1]
The MiniTT1/FlexTT5 are E-TTL II compatible with these Canon flashes:
Current Generation
600EX-RT
Supported Modes:
• Master E-TTL
• Master Manual
• Remote E-TTL
• Remote Manual
Unsupported Modes:
• Multi (stroboscopic) is not supported.
• Group mode is not supported.
• "ALL" selection is not supported, but Ratios are available in supported Master modes.
580EX II
Full feature compatibility.
Range limited due to RF interference from flash only when connected to a remote FlexTT5. See Long Range
Performance.
Not range limited when used on a transmitting radio.
430EX II
Full feature compatibility.
Excellent range performance with this flash.
270EX
Can be used on the MiniTT1 or FlexTT5 (Transmit or Receive) in ETTL mode.
Range slightly limited due to some RF interference from Speedlite only when connected to a remote FlexTT5.