Learn Mode
32
Programming FlexTT5 units for ControlTL operation when teaching with a Standard
PocketWizard
If you are using a FlexTT5 as a transmitter in your system, and you want it to learn a different ControlTL channel
from a Standard transmitter, you need to follow this sequence to make sure all of your FlexTT5 radios transmit and
receive on the same channel.
1. Teach a transmitting FlexTT5 with a standard PocketWizard.
2. Use the programmed FlexTT5 transmitter to teach all other FlexTT5 receivers. Make sure you see 3 green blinks
which confirms the ControlTL channel was learned. If you see only 1 or 2 blinks after teaching, then the FlexTT5
is listening on a Standard channel and will not receive TTL or {{PowerTracking]] information. Teach it again if
you need TTL or PowerTracking.
To Next Page
Loading...
