MiniTT1 and FlexTT5
4
Factory Reset
Sometimes you just need the settings in your radio to be like they were when you first took them out of the box.
Status LED
This section covers the various colors and blink patterns used by the Status LED.
Mounting
Radios perform best when mounted properly.
Long Range Performance
Optimize range using these techniques.
MiniTT1 and FlexTT5 Specifications
Details on radio specifics are found here.
FCC Notice
The FCC wants you to know...
References
[1] http:/ / www. pocketwizard. com/ support/ manual
[2] http:/ / www. pocketwizard. com/ products/ transmitter_receiver/
MiniTT1 and FlexTT5 Key Features
You can also learn about the MiniTT1 and FlexTT5 on PocketWizard.com
[2]
ControlTL
PocketWizard’s newest firmware platform taps into the camera’s digital communications to enable an entirely new
level of remote flash capability through our proven radio system. ControlTL allows remote TTL systems as well as
Manual Power Control. ControlTL firmware is configurable and upgradeable for “future-proof” continuous
improvement.
Dedicated TTL Triggering
Locking your MiniTT1 Transmitter into the hot shoe of a Canon or Nikon DSLR camera, and mounting flashes onto
FlexTT5 Transceivers gives you full flash exposure control with the freedom and reliability of a PocketWizard radio.
There are no special settings to make or modes to call up. Use the camera’s flash exposure controls for basic control
of remote flashes, or add an AC3 ZoneController or Canon/Nikon Master unit for even more flexibility.
Manual Power Control
To Next Page
Loading...
