Update Tab
80
• For the MiniTT1/FlexTT5 the Maintenance and Settings Tab will show after clicking the update complete dialog
box.
• Connect the next unit to update and repeat the steps above.
NOTE: If the MultiMAX has been disconnected or turned off during the update process the unit will only turn on in
USB mode. If this happens repeat the above steps to reinstall the firmware.
Factory Reset
You can perform a “Factory Reset” from within the PocketWizard Utility for your ControlTL radio. In addition,
when you update your radios via the Utility, a factory reset will be performed automatically. Your previous settings
will be saved, and when possible, you will be able to re-load them after the firmware update and factory reset. A
large jump in firmware versions or a specific change in the firmware may make it impossible to re-load, so be sure to
write down any custom settings for Configuration 1 or Configuration 2 before you reset your radios so you can
re-apply them after the upgrade.
• Click "Factory Reset"
• A dialog box that says "Are you sure you want to reset the unit to factory defaults?" will appear. Click "Yes."
• The PocketWizard Utility may flicker, and then will default to the Channel Tab.
• Your radio have now been successfully reset. To see the Factory Default Settings, see the Default Settings section
of the Factory Reset page.
Channel Tab
Utility Tab Quick Links
Update
Channel
Flash
HyperSync/HSS
PowerTracking
Modeling
Sleep
Misc
Exposure
Channels enable you to work with other photographers and to keep your triggering exclusive. Some channels operate
on different frequencies to help you avoid interference. All PocketWizard radio slaves set to the same channel work
together.
ControlTL™ uses a new channel system in addition to the Standard Channel system used in other PocketWizard
radios. The MiniTT1™ Transmitter and FlexTT5™ Transceiver can trigger all existing PocketWizard radios. They
can also be taught channels (including new ControlTL channels) by existing PocketWizard transmitters using Learn
Mode. The FlexTT5 can operate as a receiver for any PocketWizard transmitter.
When a MiniTT1 or FlexTT5 is used as a transmitter, it always sends out two triggers. One is a ControlTL trigger on
a ControlTL channel, and the other is sent on a Standard Channel. This enables you to use TTL or power-controlled
flashes alongside other manual flashes. A transmitting ControlTL radio synchronizes both triggers precisely.
To Next Page
Loading...
