PocketWizard FlexTT5 - Flash Tab

Channel Tab
82
Use ControlTL for Rx Channel Check Box (FlexTT5 Only)
This control is generally only used for performing a TTL relay from a remote camera, while triggering the camera
via a Standard Channel. For most applications where a FlexTT5 needs to receive on a Standard Channel, we highly
recommend using Basic Trigger Mode instead.
Check this box to have the FlexTT5 radio listen on a ControlTL channel (set below with ControlTL Rx Channel).
Uncheck this box to listen on a Standard channel (set below with Standard Rx Channel). ControlTL commands will
not be received.
Receiving radios can only listen on one channel at a time; either ControlTL or Standard. If your transmitter is a
MiniTT1 radio and you are triggering a remote radio that is expected to respond to E-TTL II commands, then you
must use a ControlTL channel.
If your transmitter is a PlusX, Plus II, Plus III, or MultiMAX radio, then use a Standard channel.
Flash Tab
Utility Tab Quick Links
Update
Channel
Flash
HyperSync/HSS
PowerTracking
Modeling
Sleep
Misc
Exposure
The flash tab contains controls that influence the behavior of both TTL and manual flashes connected to compatible
PocketWizard radios.