PocketWizard FlexTT5 - Modeling Tab

PowerTracking Tab
90
Aperture Centered On:
Use this control to specify the PowerTracking center point relative to aperture.
ISO Centered On:
Use this control to specify the PowerTracking center point relative to ISO.
AC9 Flash Exposure Compensation: (FlexTT5 Only)
Use this control to adjust the FEC of the flash directly connected to the AC9 in this receiving radio's hot shoe. This
setting is cumulative with other FEC values set in the system. FEC can be adjusted in +/- 3 stops.
Modeling Tab
Utility Tab Quick Links
Update
Channel
Flash
HyperSync/HSS
PowerTracking
Modeling
Sleep
Misc
Exposure
Modeling Light Control
Check this box to control modeling light behavior from the transmitter.
Un-checking this box is recommended when using battery powered remote studio strobes to disable Modeling Light
commands from being sent over the air. This effectively disables the modeling light - however, the remote modeling
can still be enabled manually via the remote flash's control panel.
Control Mode:
Determines when the modeling light will go to its active setting. Set to 'Camera Wake' to have the modeling light go
active when the camera's shutter release is half-pressed. Set to 'AF-Assist' to have the modeling light go active only
when the camera requests auto-focus assist.