HyperSync
47
HyperSync Setup
Pete Webb: “I used 2 Elinchrom Ranger RX packs, with 'S' heads, with a MiniTT1 on the
Canon 5D Mark III and FlexTT5's on the rangers.”
HyperSync timing adjustments can
only be calculated by our ControlTL
line of transmitters (MiniTT1 and
FlexTT5), but can be used by any of
our Standard or ControlTL receivers.
Depending on what you are
photographing and what equipment
you are using there are several
different ways to optimize your radios.
To learn how to use the
HyperSync/HSS Tab located in the
PocketWizard Utility to configure your
radios for optimal HyperSync
performance with your photo equipment, please visit the following page:
• HyperSync Setup
When to Use HyperSync
HyperSync has been available since just after the introduction of the MiniTT1 and FlexTT5, but we have found that
there are still many photographers who don’t know how HyperSync can help them. Below are three of the most
common uses of/reasons to use HyperSync.
Freezing Action
2 Elinchrom Ranger RX and S heads were used with PowerST4s for this photograph.
The ability to use flash above your
cameras X-Sync (in some cases up to
1/8000th!) allows you to freeze action
like never before. With HyperSync you
can light fast moving subjects without
worrying about motion blur; be it on
the sports field, dance floor, or in the
studio.
To Next Page
Loading...
