Factory Reset
76
MultiMAX Factory Reset
The procedure for resetting a MultiMAX to factory defaults is different from the procedure used for a ControlTL
radio.
1. Turn the radio off
2. While holding C, slide the power switch to TRANSMIT (TRANSMIT and RECEIVE are always reset together).
3. When you see the "CLEAR/RESET" message on the LCD, release C. The radio is reset to factory defaults.
Default Settings
When you perform a Factory Reset, the settings below are used.
MiniTT1 and FlexTT5 Default Settings
Utility Tab Quick Links
Update
Channel
Flash
HyperSync/HSS
PowerTracking
Modeling
Sleep
Misc
Exposure
Channel Tab
C.1 = ControlTL Transmit Channel = 1
Standard Transmit Channel = 1
C.2 = ControlTL Transmit Channel = 2
Standard Transmit Channel = 2
ControlTL Transmit Priority at X-Sync = enabled - Nikon FlexTT5 Only
Use ControlTL for Receive Channel = enabled - FlexTT5 Only
C.1 = ControlTL Receive Channel = 1 - FlexTT5 Only
Standard Receive Channel = 1 (but disabled) - FlexTT5 Only
C.2 = ControlTL Receive Channel = 2 - FlexTT5 Only
Standard Receive Channel = 2 (but disabled) - FlexTT5 Only
Flash Tab
Rear Curtain Sync Begins At: = Off
Optimized Rear Curtain Sync / Manual Shutter Speeds = disabled
Speedlite = Normal E-TTL/i-TTL
Force TTL Master Mode = enabled - Canon MiniTT1 and FlexTT5 Only
Pre-Flash Boost Mode = Disable Pre-Flash Boost - Canon MiniTT1 and FlexTT5 Only
Remote Beeper = No Change On Wakeup
To Next Page
Loading...
