Factory Reset
77
Remote Optical Trigger = No Change On Wakeup
HyperSync/HSS Tab
HyperSync Only (Disable HSS/FP) = disabled
HSS/FP Begins At (HyperSync Ends) = 1/250th
HyperSync Flash Duration for Standard Channels = 7
Manual HyperSync For Standard Channels = disabled
Manual HyperSync Offset (slider) = 0 (but disabled)
AC9 Flash = AB800 - FlexTT5 Only
Optimize HyperSync Automation For: = Reduced Clipping - FlexTT5 Only
P2 HyperSync Flash Duration = 7 - FlexTT5 Only
PowerTracking Tab
PowerTracking = Full Manual
Aperture Centered On: = F:11 (but disabled)
ISO Centered On: = ISO 100 (but disabled)
AC9 Flash Exposure Compensation = 0.0 - FlexTT5 Only
Modeling Tab
Modeling Light Control = disabled
Control Mode = Camera Wake (but disabled)
Modeling Light Autotrack = disabled
Modeling Light Active = 100% (but disabled)
Modeling Light Sleep = disabled
Modeling Light Sleep = 10% (but disabled)
Modeling Light Sleep Delay After Camera Sleeps = 30 secs (but disabled)
Modeling Light Delay After AF-Assist = 2 secs (but disabled)
Sleep Tab
Remote TTL Flash Sleep = disabled
Remote TTL Flash Delay = 600 secs (but disabled)
Local Flash Sleep = disabled - FlexTT5 Only
Local Flash Delay = 600 secs (but disabled) - FlexTT5 Only
Misc Tab
Basic Trigger Mode = disabled
Transmitter Only = disabled - FlexTT5 Only
Disable Shoe Communications = disabled - FlexTT5 Only
SpeedCycler = disabled
Top Shoe Detection Mode = AC3/AC9 - Canon MiniTT1 and FlexTT5 Only
Camera Model = Auto - Canon MiniTT1 and FlexTT5 Only
To Next Page
Loading...
