PocketWizard Utility
74
Preparing to Use the PocketWizard Utility for the first time
Once the PocketWizard Utility has been installed successfully you should register all USB enabled PocketWizard
units with the application. To do this follow the steps below.
1. Start the PocketWizard Utility.
2. Connect the USB cable from your computer to your PocketWizard USB enabled radio. The PocketWizard Utility
will automatically find the radio and register it in the application. This will be complete when you see the radio
information on the main screen.
3. Unplug the radio and repeat the previous steps for the rest of your USB enabled PocketWizard radios.
4. Once all of your radios have been registered, click the Check For Updates button. Refer to the Check For Updates
section for more information.
Setting the MultiMAX to USB mode
Follow the instructions on the MultiMAX FAQ.
Setting the MiniTT1/FlexTT5 to USB mode
The MiniTT1 and FlexTT5 auto detect when the USB cable has been connected. To see the battery level, the
MiniTT1 and the FlexTT5 need to be powered on for at least 3 seconds before plugging in the USB cable.
PocketWizard Utility FAQ
Having trouble with the Utility? Check out our PocketWizard Utility FAQ page!
References
[1] http:/ / www. pocketwizard. com/ support/ downloads/
To Next Page
Loading...
