5.38
Engine and Cooling Systems
21. Place the engine mount washers and fasteners (8) onto the
engine mount studs. Torque to specification.
22. Install the right hand chassis brace.
23. Apply Blue Loctite™ to the rear fasteners, install all the
rear torque stop fasteners and torque to specification.
24. Adjust the rear torque stop so that you have a clearance of
.010”-.030” (.25-.75mm) from the face of the torque stop
to the surface of the engine.
NOTE: If a new torque stop is installed, install it so
that the nub is touching the engine. This nub is .030"
(.75mm) long.
25. Adjust the engine isolator limiter (if equipped) so the stop
is bottomed out on the brace.
= T
Engine Mount Fasteners: 28 ft.lb (37.9 N-m)
= T
Rear Torque Stop Fasteners: 28 ft.lb (37.9 N-m)
= In. / mm.
Rear Torque Stop Clearance:
.010"-.030" (.25-.75mm)
Stop touching base
To Next Page
Loading...
