Polaris IQ 2007 - Drive Train; Speedometer Cable Type Drive Train Assembly

6.7
Final Drive and Brakes
6
DRIVE TRAIN
Speedometer Cable Type Drive Train
Assembly
NOTE: Set driven clutch offset following procedure
in the PVT System Chapter.
Lubricate components as outlined in the Periodic
Maintenance Table.
Tighten chaincase mounting nuts using a criss-
cross pattern.
Install jackshaft seal sleeve with beveled edge
towards brake disc, then install o ring inside sleeve.
A
B
C
D
E
E
= T
A = Driven Clutch Fastener = 17 Ft.Lbs. (23 Nm)
B = Jackshaft Flange Nuts = 17 Ft.Lbs. (23 Nm)
C = Speedometer Housing Nuts = 17 Ft.Lbs. (23 Nm)
D = Driveshaft Housing Nuts = 17 Ft.Lbs. (23 Nm)
E = Chaincase Mounting Nuts = 28 Ft.Lbs. (38 Nm)
CAUTION
Do not over-torque the chaincase mounting nuts.