3.12
Maintenance
Fuel Filter - CFI Models
1. The fuel filter should be replaced as outlined in the
periodic maintenance table. For information involving de-
pressurizing the fuel system and disconnecting fuel hoses,
See “Cleanfire™ Fuel Injection” on page 4.15.
2. After de-pressurizing the fuel system and disconnecting the
fuel hoses, remove the fuel filter cartridge from the bracket.
Dispose of any fuel in an appropriate container, then
discard assembly.
3. When re-connecting the fuel hoses, verify the connections
are secure by firmly pulling on the two hose connections.
Push the filter cartridge back into the bracket.
4. To prime the fuel system after installing a new filter,
connect a 12 volt Vdc battery to the fuel pump prime plug.
See “Diagnostic Plugs” on page 11.18.
Oil Filter
All models feature an inline oil filter located between the oil
reservoir and oil pump. Always bleed the oil supply hose and oil
pump of air after replacing the filter.
Install the oil filter so that the directional arrow points towards
the oil pump.
WARNING
When removing the fuel filter fuel spillage will occur. Be
sure to work in a well ventilated area away from
anything which may cause the fuel to ignite such as an
open flame, heaters, trouble lights or cigarettes.
FUEL FILTER / SUPPLY HOSE
FUEL FILTER BRACKET
OIL LEVEL SENDER
VENTED CAP
GROMET
FILTER
To Next Page
Loading...
Need help?
General
