Polaroid Spectra/Image One Board - Releasing Connectors from Ranging Board

15
5. Release connectors J1, J2 and J3 from the ranging board by grasping the wires
between your thumb and index finger and rocking the connector from side to side
(Figure 2-6).
Figure 2-6. Releasing connectors from ranging board
6. Release the white wire (J5) and the brown wire (J4) from the MiniSert self-locking
terminals on the ranging board (Figure 2-7).
7. Release the paired black/red transducer wires from connectors J1 and J20 on the
ranging board (Figure 2-7). Straighten out the bare ends of the wires bent back over
terminals J19 and J20. Then either: (a) pull the wires out of the terminals, or (b)
unsolder them and pull them out.