63
Operating Problems and Typical Causes
Typical causes of these operating problems are listed on the following pages:
Problem Page
No Dark Slide 4 - 6
Incomplete Dark Slide 4 - 6
Blades don’t Open 4 - 7
No S1 Cycle 4 - 7
Sticky S1/S10 4 - 7
Sensitive S1 4 - 8
No Motor Drive 4 - 8
Counter Wheel Hangs Up 4 - 8
Poor LCD Module Connection 4 - 9
LCD Display Problems (Missing/Extra Segments, Shadows) 4 - 9
Buttons don’t Work or Hard to Press 4 - 9
Erratic Camera behavior 4 - 9
No Self-Timer or Incorrect Self-Timer Cycle 4 - 10
No Piezo 4 - 10
Incorrect Piezo Speed 4 - 10
No End-of Pack Chime 4 - 11
Incorrect Blade Speed 4 - 11
Motor doesn’t Run 4 - 11
Film Speed Switch Failure 4 - 11
Quintic Hangs Up 4 - 12
Strobe Exposure Adjustment Failure 4 - 12
Ambient Exposure Adjustment Failure 4 - 12
Strobe Doesn’t Fire 4 - 13
Strobe Fires at Wrong Time 4 - 13
LED’s Don’t Light or Light at Wrong Time 4 - 13
Ranging Incorrect 4 - 13
Ranging to 8 FT/M Only 4 -14
IC Timeout Error 4 -14
Exposure: Long Timeout 4 -14
To Next Page
Loading...
