67
Poor LCD Module Connection
Typical causes:
• Elastomeric connector contaminated
• Elastomeric connector damaged
• Elastomeric connector size out of spec
• Contamination on gold fingers (LCD or RM)
• Elastomeric connector screws not tightened
• LCD and/or RM excessively warped
LCD Display Problems (Missing or Extra Segments, Shadows in Display)
Typical causes:
• Bezel not tight
• Glass improperly seated
• Defective glass
• Defective LCD module
• Gold pads under LCD glass contaminated
Buttons don’t Work or are Hard to Press
Typical causes:
• Rubber switches loose or missing
• Plastic buttons hung up on flash
• Features cap not seated
• Mid Cover not seated
• RM not seated
• RTV on RM incorrectly applied (prevents RM from seating)
• LCD module excessively warped
Erratic Camera Behavior
Typical causes:
• Poor LCD module connection
• LCD module defective
• RM defective
• ONEBD not seated to RM
• Dirty solenoid
To Next Page
Loading...
Need help?
General
