23
Section 3 - Testing and Adjustments
Spectra Pro/Image Pro/Minolta Pro System Functional Test
Purpose
The purpose of the functional test is to determine if the camera is operating properly
during various phases of simulated operation. In this test the camera is cycled through
dark slide, strobe exposures, non-strobe exposures, and end-of-pack. The intent is to
isolate problems for troubleshooting. If the camera does not operate as described
below, consult the troubleshooting chart most closely allied with the problem.
Equipment Required
• Film Pack Simulator #12467
• Film Pack Simulator Adapter #13130
• Power Supply - Power Mate #12531 or Lambda #12429
To Next Page
Loading...
