Polaroid Spectra/Image One Board - Specific Problem Causes: Dark Slide to LCD Issues

64
No Dark Slide
Typical causes:
• Motor flex not seated to wireform switch
• Poor connection to LCD module
• Red or black wire not seated to strobe (J14-J15)
• Erect pin missing
• Wireform switch block distorted
• Flex not seated to motor
• Wire broken on wireform switch block
• Wireform switch block melted
• S-9 switch distorted at wireform switch block
• Wire connector from motor flex not connected to One Board
• Pick spring not seated
• Door link not making VER switch to battery switch (at wireform switch block)
• Counter wheel hang up
• Battery contacts not seated or missing
• Door latch distorted
• Shutter not seated
• No S1 cycle (See No S1 Cycle, Page 4-7)
Incomplete Dark Slide
Typical causes:
• Locking cap on Ranging Board Burndy connector not closed
• Poor LCD Module connection at Ranging Board
• Defective RM