5
Section 1 - General Description
Scope of This Addendum
This Service Manual addendum describes only those One Board Spectra Pro/Image
Pro/Minolta Pro mechanical parts, electronic circuits, operating modes and service
procedures that are different from those of the Spectra camera. Information common to
One Board Spectra Pro/Image Pro/Minolta Pro cameras and Spectra cameras is not
included in this addendum. Refer to Spectra Service Manual for this common
information.
To use this addendum effectively, you should also be familiar with the design, operation,
disassembly and calibration information presented in the Spectra Manual.
This addendum applies only to Spectra Pro/Image Pro/Minolta Pro cameras with the One
Board Strobe/Exposure Module Assembly (Part No. 1B0632A) installed. (These cameras
can be identified by the letter G as the tenth character in their serial numbers.) For
servicing Spectra Pro/Image Pro/Minolta Pro cameras without the One Board assembly,
see Spectra Pro/Image Pro Camera Service Manual Addendum of January, 1990.
The name Spectra Pro as used in this addendum refers to the Spectra Pro, Image Pro
and Minolta Pro cameras unless otherwise noted.
Spectra Pro/Image Pro/Minolta Pro Operating Differences
The major differences between Spectra Pro/Image Pro/Minolta Pro cameras and
Spectra cameras relate to the operating modes available to the user, how they are
selected and how their status is displayed.
To Next Page
Loading...
Need help?
General
