65
Blades don’t Open
Typical causes:
• Shutter not seated
• SOL 1 not adjusted properly
• Wire connectors not connected to SOL 1 or SOL 2
• Kicker spring not seated
• Solenoid not seated straight
• Sticky blades
• No SOL 1 drive
• Drive link not seated to walking beam
• Encoder wire hitting SOL 2 plunger
• Base block Quintic post distorted
• SOL 2 plunger sticky
• Wireform switch not in correct position
• Broken drive link
• Catch pawl hang-up
• Photodiode not glued properly
• SOL 2 moves in frame
• Encoder lead broken
• Counter wheel hang up
• Door latch distorted
• Black and red wires not seated to Strobe Board (J14-J15)
• Poor LCD module connection (See Poor LCD Module Connection, Page 4-9)
No S1 Cycle
Typical causes:
• S1/S10 switch distorted
• Wire connectors not seated to RM, FM, Strobe or motor flex
• Defective Strobe
• Poor LCD Module connection (See Poor LCD Module Connection, Page 4-9)
• LCD module defective
Sticky S1/S10
Typical causes:
• Button hung up on top cover insert
• S1/S10 button bezel not seated
To Next Page
Loading...
