Polaroid Spectra/Image One Board - Ambient Exposure Adjustment Failure; Quintic Hangs up; Strobe Exposure Adjustment Failure

70
Quintic Hangs Up
Typical causes:
• Quintic post distorted
• Quintic frame damaged
• Counterweight
• Quintic return spring
• Encoder wire not seated
• Flash on baseblock
Strobe Exposure Adjustment Failure
Typical causes:
• Photodiode cap not seated
• Cal wedges not seated, missing or distorted (check IC, pin 7)
• Transducer clip broken
• Defective flashtube
• Defective strobe
Ambient Exposure Adjustment Failure
Typical causes:
• Cal wedges not seated, missing or distorted
• Photodiode cap not seated
• Yellow dot in wrong position (do not remove any yellow dots)
• Adjusting gear wheel not catching wedge