Configuring KIRK Wireless Server 6000
10–11
5 In the Registation Expire(sec) field, type the number of seconds before a
SIP registration will be renewed.
The default value is 3600.
6 In the Max Forwards field, type a value (optional).
The default value is 70.
7 From the SIP Type of Service list, select between Nothing, Low delay,
Reliability, Throughput and Minimum cost.
The default setting is Nothing.
8 In the Default User field, type the user name.
9 In the Default Password field, type the password (optional).
Note: If no handset specific authentication user name/password is
configured, handsets registered on the KWS6000 will use the default user
name/password for authentication.
10 Select the Send as RTP check box (Real-time Transport Protocol), if you
want the keypad signalling sent as RTP packets with DTMF code
(optional).
11 Select the Send as SIP Info check box, if you want the keypad signalling
sent as SIP INFO (optional).
12 In the Tone Duration(msec) field, type the time length of the tone in
miliseconds.
The default value is 270.
13 Select the Enable Indication check box, if you want to handle MWI
message (optional).
14 Select the Enable Subscription check box, if you want to subscribe to
MWI indications from the SIP proxy (optional).
15 In the Subscription Expire(sec) field, type a value.
The default value is 3600.
16 From the Packet Duration(msec) list, select between 10, 20 and 40.
17 From the Media Type of Service list, select between Nothing, Low delay,
Reliability, Throughput and Minimum cost.
The default setting is
Nothing.
18 In the Port Range Start field, type a value.
The default value is 58000.
19 In the Codec priority fields, define the priorities of codecs.
20 Click Save to save your SIP configuration data.
To Next Page
Loading...
Need help?
General
