KIRK Wireless Server 6000 Installation and Configuration Guide
6–6
1 Mount the base station on the wall using the anchors and screws
accompanying the product.
Note: When you place the base station on the screws, ensure that the
screws do not touch the printed circuit board.
Figure 6-4 Base Station Wall Mounting
2 Connect the RJ45 plug to the ethernet connector at the bottom of the base
station.
00
Figure 6-5 Base Station - Ethernet Connector
Recording the Installation Information
After completing the installation of the base stations, record the location of
each base station and add a descriptive text in the Administration Page of the
KWS6000 under Administration/Base stations.
Caution:
Do not mount the base station on soft surfaced walls such as those covered
with canvas, metal or sponge-like materials.
To Next Page
Loading...
