10–1
10
Configuring KIRK Wireless Server 6000
This section provides you with information on how to power up the KWS6000
and connect the unit to a computer. It also provides information on how to
configure a KWS6000 through the web based Administration Page using
either DHCP or static IP address.
This section includes information about:
• “Powering up the KWS6000 Server and Media Resource” on page 10-1
• “Connecting a Computer to the KWS6000” on page 10-2
• “Accessing the Web Based Administration Page” on page 10-3
• “Configuring a KIRK Wireless Server 6000 Using Static IP Address” on
page 10-7
• “Configuring a KIRK Wireless Server 6000 Using DHCP” on page 10-13
• “Checking Indicators” on page 10-15
• “Making a Back-Up of the Configuration File” on page 10-15
Powering up the KWS6000 Server and Media Resource
After installing the KWS6000 server you need to power up the unit using:
• Power supply for KWS6000: 8VDC, 1 W maximum when using local
power supply.
After installing the KWS6000 base station you need to power up the unit using:
• Power supply for KWS6000: 48VDC, 1 W maximum when using local
power supply.
Note
The KWS6000 is pre-configured to use a static IP address.
To Next Page
Loading...
