KIRK Wireless Server 6000 Installation and Configuration Guide
12–10
• “General Configuration” on page 12-10
• “Base Station Configuration” on page 12-11
• “Security Configuration” on page 12-11
• “Sync. Ways Configuration” on page 12-11
General Configuration
On the General Configuration page you define IP and DNS settings for the
base station.
1 Click Configuration, and then click General.
Figure 12-10Adm. Page Base Station: Configuration/General page
2 Click Use static IP address.
3 In the IP addr field, type the IP address of the base station.
4 In the Netmask field, type 255.255.0.0.
5 In the Gateway field, type IP address of the default gateway (optional).
The default gateway serves as an access point to another network.
Contact your system administrator for more information.
6 In the MTU field (Maximum Translation Unit), type the size of the largest
packet, that your network protocol can transmit (optional).
7 In the Domain field, type the domain name of the system (optional).
8 In the Server field (under DNS - Domain Name System), type the IP
address of the domain name (optional).
To Next Page
Loading...
