Configuring KIRK Wireless Server 6000
10–7
Configuring a KIRK Wireless Server 6000 Using Static IP
Address
This section describes how to configure a KWS6000 using static IP address.
Figure 10-6 KWS6000 installation
For information on accessing the web based Administration Page, refer to
“Accessing the Web Based Administration Page” on page 10-3.
This section contains information about:
• “General Configuration” on page 10-8
• “Wireless Server Configuration” on page 10-9
• “Built-In Media Resource Configuration” on page 10-9
• “SIP Configuration” on page 10-10
• “Security Configuration” on page 10-12
Note
The KWS6000 is pre-configured to use a static IP address. It is strongly
recommended to configure the KWS6000 using static IP address.
To Next Page
Loading...
