KIRK Wireless Server 6000 Installation and Configuration Guide
8–6
This section describes how to install the battery on a 4020/4040/4080 Handset.
1 To change the battery unscrew the plate on the rear of the handset to
access the battery compartment. Use a normal screw driver.
2 Insert the screwdriver into the small crack behind the blind cover and
break to open the handset.
Figure 8-2 Remove Back Cover from Handset with Screw Fastener
3 Place the battery plug in the slot in the battery box.
4 Insert battery with the label readable.
5 Replace the back cover.
Installing Battery on KIRK 5020 and KIRK 5040 Handsets
This section describes how to install the battery on a 5020 Handset.
1 To install the battery press down the back cover and slide it towards the
bottom of the handset.
Figure 8-3 Remove Back Cover from Handset
2 Lift off back cover.
To Next Page
Loading...
