Polycom RealPresence Group 310 Administrator's Guide

Configuring Audio Settings
Topics:
• Configure General Audio Settings
• Configure Audio Input Settings
• Audio Output Settings
• Stereo Settings
• Test StereoSurround
• Polycom Acoustic Fence
• USB and Bluetooth Headset Support
Configure General Audio Settings
You can configure audio settings in the system web interface.
Some audio settings are unavailable when you connect a SoundStructure digital mixer to your system.
Procedure
1. In the system web interface, go to Admin Settings > Audio/Video/Content > Audio.
2. At General Audio Settings, configure the Audio settings described in the following table.
Setting Description
Polycom
StereoSurround
Enables Polycom StereoSurround software for all calls. When enabled, the Stereo
Settings become available.
To use StereoSurround, make sure you correctly configure your system’s stereo
settings.
Sound Effects Volume Sets the volume level of the ringtone and user alert tones.
Ringtone Specifies the ringtone for incoming calls.
User Alert Tones Specifies the tone for user alerts.
Audio Mute Auto-
Answered Calls
Specifies whether to automatically mute incoming calls.
Note: You must first enable Auto Answer Point-to-Point Video or Auto Answer
Multipoint Video in Call Settings to use this feature.
Polycom, Inc. 140

Polycom RealPresence Group 310 Specifications

General

Network Protocols	H.323, SIP
Network Interfaces	1 x 10/100/1000 Ethernet
Video Resolution	1080p, 720p
Audio Standards	G.711, G.722, G.722.1, G.728, G.729A
Video Standards	H.263, H.263+, H.264, H.264 High Profile
Network	10/100/1000 Ethernet
Video Input	1 x HDMI
Video Output	HDMI
Audio Input	1 x 3.5mm stereo line-in
Audio Output	1 x 3.5mm stereo line-out
Other Interfaces	2 x USB 2.0
People Video Resolution	1080p
Content Sharing	People+Content IP
Security	AES
Camera	Polycom EagleEye Acoustic or EagleEye IV