Polycom RealPresence Group 310 Administrator's Guide

EagleEye Director II Camera System Diagnostics
Most diagnostic information is available on both the web and the local interface, but some information is
specific to one or the other interface. From the web interface, go to Diagnostics > Audio and Video
Tests > Camera Tracking.
The screen includes the following diagnostic information for your camera system.
Diagnostic Screen Description
Speaker Test Tests the audio cable connections. A 473 Hz tone indicates that
the local audio connections are correct.
If you run a test during a call, people on the far site also hear the
test tone.
If you run the test from the system web interface during a call, the
people at the site you are testing hear the tone, but you don’t.
If you run the test from the system web interface during a call, the
people at the site you are testing will hear the tone, but you will
not.
Audio Meters Measures the strength of audio signals from ten internal
microphones, far-site audio, and any device connected to the
audio line in.
Meters function only when the associated input is enabled.
Note: Some audio meters are unavailable when a SoundStructure
digital mixer is connected to the room system.
Configuring a Camera or Camera Control System
Polycom, Inc. 175

Polycom RealPresence Group 310 Specifications

General

Network Protocols	H.323, SIP
Network Interfaces	1 x 10/100/1000 Ethernet
Video Resolution	1080p, 720p
Audio Standards	G.711, G.722, G.722.1, G.728, G.729A
Video Standards	H.263, H.263+, H.264, H.264 High Profile
Network	10/100/1000 Ethernet
Video Input	1 x HDMI
Video Output	HDMI
Audio Input	1 x 3.5mm stereo line-in
Audio Output	1 x 3.5mm stereo line-out
Other Interfaces	2 x USB 2.0
People Video Resolution	1080p
Content Sharing	People+Content IP
Security	AES
Camera	Polycom EagleEye Acoustic or EagleEye IV