2. Scroll to the Power section.
3. Select Touch Control Power.
4. In the menu that appears, select Power Off the Touch Control.
If you choose to power off the Polycom Touch Control, you must disconnect and reconnect the
LAN cable to power it on again.
Wake the Polycom Touch Control
The Polycom Touch Control goes to sleep after two minutes of inactivity.
Procedure
» Touch anywhere on the screen to wake the device.
Pairing States for the Polycom Touch Control
The Polycom Touch Control device displays the following pairing states:
State Description
Paired The Polycom Touch Control is successfully connected
to the RealPresence Group Series system through the
pairing process, including providing the system admin
ID and password. A single Polycom Touch Control can
be paired to multiple RealPresence Group Series
systems and, once paired, the Polycom Touch Control
can switch between systems without needing to enter
admin IDs or passwords.
Unpaired The ability to pair or connect to the Polycom Touch
Control is disabled on the RealPresence Group Series
system.
Connected A Polycom Touch Control has an active pairing
connection to the RealPresence Group Series system.
A single Polycom Touch Control can be paired to
multiple systems, but can be connected to only one
RealPresence Group Series system at a time.
Disconnected The Polycom Touch Control does not have an active
pairing connection to a system, but is still paired if at
least one system that has previously paired with the
Polycom Touch Control has not unpaired.
Related Links
Unpair the Polycom Touch Control Device on page 244
Setting Up a Polycom Touch Control Device
Polycom, Inc. 243
To Next Page
Loading...
Need help?
General
