113
Polyend Play Manual Rev 1
NOTES
Sequencing Patterns
6
Chord and Bass Fills
As well as creating chord lls and bass lls, both can be created together
using the chord and bass ll option. Up to 64 steps can be used across 5
selected tracks to create a 4 polyphonic chord plus a single track bass line .
The same pre-requisite set up also applied to this option including the SD
Card ‘MelodyFills’ folder and the bass and synth sample pool folders with
samples populated.
▌ CREATING PATTERNS FROM BASS AND CHORD FILLS.
1. To use this Fill function ensure that the sample pool contains a bass
and also a synth folder.
2. The length of the tracks can be up to 64 steps. Set a track length for all
tracks to suit the pattern required.
3. Select 5 track channels to ll into by pressing the [Select] function pad
buttons for the respective tracks. Rows represent tracks. The Track will
illuminate blue and the track select function button lit bright green.
4. Press [Fill] button. Initial selection of ll will select the mode. When
subsequently pressing the [Fill] button within the ll mode, a ll will be
initiated to populate steps on selected tracks.
5. Select ‘Chords and Bass’ Fill algorithm. Ensure the upper ll parameter
is set to ‘Chords and Bass’. Press the left side [Screen] button to ensure
the algorithm type is in focus. Turn (Screen) when the upper parameter
is highlighted to select the algorithm.
6. Set the ‘Chords and Bass’ Fill genre. Press the left side [Screen] button
to ensure the algorithm genre is in focus. Turn (Screen) when the lower
parameter is highlighted to select the genre preset. This is a pre-
programmed pattern from a factory selection of 48 patterns.
7. Press [Fill] button again. The selected steps will be populated with the
pattern based on genre preset and samples from the sample pool.
8. The programmed note samples can be changed individually to another
sample by manually selecting it.
To Next Page
Loading...
