191
Polyend Play Manual Rev 1
System
11
NOTES
11.2 Generic Firmware Update
Firmware updates may be provided by Polyend from time to time, to x
bugs or add new features. The process of updating can be performed in
several ways. When performing updates it is strongly advised to follow the
Polyend instructions supplied with each update. The instructions here are a
generic guide only.
▌ FIRMWARE UPDATE
1. Download the latest rmware. Access rmware updates for your device
from your registered account at Polyend.
2. Copy the downloaded .ppf rmware le into the /Firmware folder. This
can be found in the root directory of the SD Card.
3. Insert the SD card into Play and power up.
4. Press (Screen) knob to open the conguration and settings menu.
5. Navigate through the ‘Settings’ and ‘Firmware’ menus. Open the
‘Firmware Update’ function, highlight the rmware version to install.
6. Press (Screen), knob to select rmware.
7. The screen will prompt “yes’ or ‘No’ to conrm using the left screen
buttons. To continue press [Yes].
8. The rmware will install and the on screen prompts provided will guide.
The install process is typically less than 1 minute.
9. Play should restart automatically. If not and only when the update is
100% completed, Press On/Off to perform a manual start.
Menu - Select Firmware - Select
Download rmware
(Screen) - ‘Firmware’ - (Screen)
Sub Folders
SD Card
/Root Directory
/Firmware
PolyendPlay_v1.3.0.ppf
PolyendPlay_v1.4.0.ppf
1
2
3
5 64
To Next Page
Loading...
