125
Polyend Play Manual Rev 1
NOTES
Arrangements & Variations
7
7.2 Managing Patterns
Patterns can be selected from a total of 128 pattern slots. Patterns can be
created and edited individually or copied and pasted and then further
editing performed.
▌ SELECTING / CREATING A PATTERN
1. Press [Patterns] from sequencer mode to select pattern mode. If in
pattern mode, pressing [Patterns] will toggle to sequencer mode.
2. Press [Pad] to select an existing pattern to edit or play or to create a
new pattern from an empty slot. Pads represent patterns and are laid
out across the 8 x 16 grid with a total of 128 pattern slots available. The
selected pad is lit Orange.
3. The selected pattern can now be played or edited in sequencing mode,
selected by pressing [Patterns] from pattern mode.
▌ COPYING A PATTERN
1. Press [Patterns] from sequencer mode to select pattern mode. If in
pattern mode, pressing [Patterns] will toggle to sequencer mode.
2. Hold [Pad] for the source pattern to copy from. Only one pattern can be
copied at once.
3. While still holding the source pad, Press [Pad] for the destination slot to
copy into.
▌ DELETING PATTERNS
1. Press [Patterns] from sequencer mode to select pattern mode. If in
pattern mode , pressing [Patterns] will toggle to sequencer mode.
2. Hold [Pad] for the target patterns to delete. Multiple pads / patterns can
be selected.
3. While still holding the target pads, Press [Shift] + [Delete]. The delete
command is the secondary function on the Fill button.
Quick Copy: Note that quick copy can operate for steps, step pages, Patterns and
Variations. Quick copy is performed by keep holding the source [Pad] for about half a
second + Press [Pad] for any destination pads. Pads will ash blue twice when
copied to the clipboard and when pasted.
To Next Page
Loading...
