139
Polyend Play Manual Rev 1
NOTES
Arrangements & Variations
7
Randomize Examples
Randomize 0% - 100%.
X% sets the strength of randomization which refers to the range of values to affect.
The parameter to randomize is set by the Randomize Type. Steps must be
selected as well as the Randomize parameter page being actively on display for
randomization to be applied.
Sample Pool 1 Octave
1 Octave 1 Octave
Randomize ‘50%’ - Type ‘Sample In Pool’
A sample will be selected randomly from within the sample pool. The selection
of samples will operate across a range of 50% of the sample pool.
Randomize ‘80%’ - Type ‘1 Octave’
The step note / event will play a notes from within an octave range. The notes
will be selected across a range of 80% of the octave.
Randomize ‘40%’ - Type ‘Space’
The Space patch which consists of Panning, Delay Send and Reverb Send will
be applied on the selected steps. The strength of parameter value application
is based on the Randomize setting, in this case 40%. Try different % values for
each step in the track.
Randomize ‘30%’ - Type ‘Sample Length’
Create glitchy steps, ideal for chopping samples randomly. Sample Start and
End will adjusted within the 30% range.
Randomize
Randomize Type
Volume
Panning
Reverb Send
Delay Send
Sample Start
Sample End
1
1 1
22
33 3 3 4 4
2
3
4
50% 80%
40% 30%
To Next Page
Loading...
