89
Polyend Play Manual Rev 1
NOTES
▌ PICKING & PLACING A SAMPLE
1. Ensure sequencing mode is selected. If pattern mode or perform mode
is selected, Press [Patterns] or [Perform] respectively to toggle back to
Sequencer mode. This is the grid view which allows an individual
pattern to be sequenced.
2. Pick a Sample:-
• Double Tap (Sample) to switch to the folder - (Folder) parameter.
Turn (Folder) to browse the sample folders. Any folders that are
empty will not be displayed. Select a desired sample folder.
• Turn (Sample) to browse and select the sample in the current folder.
If the pattern is not playing, the audio will be previewed audibly
when the sample is selected.
• The left side [Screen] buttons will also select between the two
parameters and turning the (Screen) knob will also change the
selected parameter. This is equivalent to using the parameter knob.
3. Adjust the parameters to establish the work step settings. The sample
and parameters will be applied to any step placed on the grid.
4. Place the Sample as a note step.
• Tap one or more pads to place the step. The sample and the
parameter settings of the work step will be applied on each step
where the sample is placed.
• Active note steps are lit white. Empty steps are unlit.
• Steps can be placed on any track row and in any of the pattern
columns. Note that the grid shows 16 steps across 8 tracks. There
maybe other step pages selectable with the [Shift] + [16], [32], [48]
or [64]. A maximum of 64 steps is available.
• Tapping an existing active note step will delete it from the grid.
5. Press [Play] to play the current pattern. Notes can be placed while the
pattern is playing.
Sequencing Patterns
6
To Next Page
Loading...
