THE ART OF WELDING
P6
PN-0509076 Rev. 16 19-92
Remote control unit 6 axis3. 3. 2.
All functions and parameters can be monitored and
changed by the remote control unit (option):
Positioning welding heads and wire feeders.•
Starting and stopping weld cycles.•
Selecting WPs and programs.•
Simulating weld programs.•
Minor modifi cations during a weld cycle.•
Shielding gas test.•
Manual starting of the cooling pump.•
Remote control pendant 4 axis3. 3. 3.
All operations and parameters can be controlled by
the remote control pendant:
Set up of Welding heads and wire feeders.•
Start and stop of weld cycles.•
Selection of WPs and programs.•
Simulation of weld cycles without arc.•
Parameter modifi cations during a weld cycle.•
Shielding gas test.•
Manual start of the cooling pump.•
Fig. 3.12 - P6 remotes control unit
To Next Page
Loading...
